Power Tools
Electric Drill/Rotary Hammer: Used for drilling into walls and securing expansion bolts; suitable for wall materials of varying hardness.
Impact Wrench/Electric Screwdriver: Used to rapidly tighten numerous mounting screws, enhancing the efficiency of module and frame installation.
Cutting Machine/Angle Grinder: Used for on-site fine-tuning of square steel and profiles to accommodate non-standard installation scenarios.
Measurement and Alignment Tools
Laser Level: Used to establish installation reference lines, ensuring the entire screen is straight and level to prevent image misalignment.
High-Precision Tape Measure/Steel Ruler: Used for accurate measurement of wall and frame dimensions, helping to minimize module assembly tolerances.
Steel Square: Used to verify 90-degree angles in steel structure welding, preventing frame deformation.
Electrical Tools
Multimeter: Used to check voltage, current, and signal continuity, enabling rapid troubleshooting of power supply and wiring issues.
Wire Strippers/Crimping Tools: Used for proper termination of power and signal cables, preventing poor contact or short circuits.
Network Cable Tester: Used to verify signal cable continuity, allowing for the early detection and resolution of transmission faults.
